Product » NetworX Series

There were 3 articles found in this Section:

1. How do I delete and enroll and wireless transmitter, I have an NX8 control and NX548E wireless receiver?
   To delete a transmitter zone 9 used as an example) 1. Enter * 8 at the keypad. (On LED touchpads, the five function lights start flashing.) 2. Enter the program code (factory default is 9 7 1 3). (On LED touchpads, the service light flashes and the five function lights change from flashing to o ...
2. How do I enroll the NX470 keyfob into my NX-6-FP-7-RF system?
   To enroll the NX470 as zone 9, for example: Press * 8 9713 192 # 910 # (exit key) (exit key) wait about 30 seconds and then continue Press * 8 9713 192 # 594 # 0 * 400 # 9 * (hold the top 2 buttons down at the same time on the nx470) you should hear a ping noise from the keypad confirming enrol ...
3. NX-4-FP - Simple Programming Example.
   After you have wired the control and have a list devices wired to each zone, you can apply ac and battery power. You will usually hear a beeping keypad upon power up,this can be stopped by pressing 1234 at the keypad. For this example we will use the zone list below Zone 1= Front delay door Zon ...