Product » LynxR

There were 3 articles found in this Section:

1. LynxR - How do I program User codes?
   The following will explain how to add, change, or delete the master or user codes on the Lynx. Watch out for: Are you taking too long between Keystrokes? The keypad gives no confirmation or prompts until all keystrokes are completed. Do you have the right Authority? The installer must assig ...
2. LynxR - Basic programming Tips
   Pressing the Installers Code + 8 + 0 + 0 Allows entry into program mode. If the installer code is not known you can enter programming by powering down the panel then powering back up & pressing [*] + [#] simultaneously within 50 seconds of power up If the panel has been locked out remotely s ...
3. LynxR - How can I program the keypad panic?
   Step 1: Enter Program Mode, Installer Code (4112) + 8 + 0 +0 If this key sequence does not work or you do not know the installer code you can power down the system (AC & DC) then power back up & within 50 seconds press & hold the [*] + [#] keys simultaneously for about 5 seconds this should get ...