Product » Orbit 6

There were 11 articles found in this Section:

1. Orbit 6 - How do I change the Master Code?
   The Orbit 6 siren circuit can accomodate up to a 750 milliamp draw.Check the sirens specs to be sure the 750ma spec is not exceeded. An optional power supply and relay will be required if the total current draw exceeds 750ma.The item PWRKT is recommended in this case
2. Orbit 6 - Can the Orbit 6 deliver a voice message when calling private phone numbers?
   Yes, as long as the optional RP200VC voice module is being used.
3. Orbit 6 - How do I program my phone numbers?
   To program the first phone number,Press * 71 (1234 or current master code) then enter the phone number as dialed then press # To program the second phone number, Press *72 (1234 or current master code) then enter the phone number as dialed then press #
4. Orbit 6 - How do I change the Master Code?
   Press 0206 # press * 10 (arm key) enter new 4 digit master code then # Press 0206 (arm key) to exit
5. Orbit 6 - Why are all the zone lights lit?
   If the contacts are all closed,check to see that each zone has 1 2.2k ohm resistor wired in series
6. Orbit 6 - How do I set the Date?
   Press * 61 (1234 or current master code) then enter mm dd yy
7. Orbit 6 - How do I enter Installer Programming?
   Press 0206 # (System must be disarmed before programming.)
8. Orbit 6 - Why is the Power light flashing?
   A flashing power light indicates a system trouble.To discover the cause of the system trouble press * 3 then refer to the guide below, Page 24 of the User's manual also has info available If the FIRE light is lit= fire zone trouble, check for resistor placement If 1 is lit= low system battery If ...
9. Orbit 6 - How do I set the time?
   Press * 6 2 then (1234 or current master code) then enter the time using military time 1pm = 1300 for example
10. Orbit 6 - How do I connect a motion detector to the Orbit 6 control?
    You'll need to run a 22 gauge 4 conductor wire from the Orbit 6 control to the hardwired motion detector.For example let's use the colors red, black, yellow and green.The red wire will be used to connect to the 12vdc+ terminal at the motion detector and connects to the Orbit 6s AUX terminal.The ...
11. Orbit 6 - How many keypads can be connected to the Orbit 6 control?
    A total of 4 using any combination of l.e.d. or l.c.d. keypads.