Product » Wisdom

There were 10 articles found in this Section:

1. Rokonet Wisdom - My external siren is wired correctly but doesn't work, what could the problem be?
   The positive siren wire will connect to the Wisdoms BELL+ terminal The negative siren will connect to the Wisdoms BELL - terminal The programming step below is also needed, it enables the external bell output. press * 9 # 0133 # 1 2 31 # (use shaded lock button to change the N to a Y) then ...
2. Rokonet Wisdom - How do I change the Grand Master Code?
   Press * 5 (current grand master code, 1234 from the factory) then press # (you will see 1. User Codes) Press # (you will see Define/Change) Press # then enter new 4 digit code then press # (you should see"accepted" on display) Press the * key repeatedly until you are out of this programming section.
3. Rokonet Wisdom - Why is the trouble light flashing?
   Press * 3 # # then your 4 digit grand master code followed by the # key.You will hear verbal messages indicating the trouble condition.
4. Rokonet Wisdom - How do I exit the programming mode?
   Press the * key repeatedly until there is no change on the display then press 0 #
5. Rokonet Wisdom - How do I wire an external siren to the Wisdom control?
   The positive wire will connect to the Wisdoms Bell+ terminal the negative wire will connect to the Wisdoms Bellterminal Some sirens offer a choice between a "steady" or"warble" sound and will have 3 wires to choose from, use only the 2 wires for the sound you desire, the 3rd wire will not be used.
6. Rokonet Wisdom - How do I enter the programming mode?
   Press * 9 # 0133 #
7. Rokonet Wisdom - Which modular phone connection on the back of the Wisdom control should be connected to the phone jack on the wall?
   The modular connection labelled U03 will be used.It is also the smaller of the 2.
8. Rokonet Wisdom - How do I enroll a wireless transmitter into the system?
   Step 1- enter programming Press * 9 # then 0133 #. Step 2- Press 2 # # (you will see "Zone Allocation") select 01 (you may also enter any 2 digit zone number you wish to add, instead of 01) then press #, Press 2 # the system will begin counting, now it will be time to trip the sensor by removin ...
9. Rokonet Wisdom - How do I set the Time and Date?
   A. Press * 6 # then the current grand master code then # (you will see "system time") Press # then enter the 4 digit time followed by the # key. Press the"Down/Right" Arrow key and you will see "System date Press #.Now enter the 2 digit day then press the"Shaded Lock" button until the desired mo ...
10. Rokonet Wisdom - Why does the display show "EE U/D Accessory Not Found"
    A. The reason this message will be displayed is because the "J9" jumper located on the main controls circuit board is across both pins.To correct this message , remove all power and place the J9 jumper on one pin only, then re-apply all power.