To delete a transmitter zone 9 used as an example)

1. Enter * 8 at the keypad. (On LED touchpads, the five function lights start flashing.)

2. Enter the program code (factory default is 9 7 1 3). (On LED touchpads, the service light flashes and the five function lights change from flashing to on steady.)

3. Enter the DIP switch setting module number of the wireless receiver(factory default on the NX548E is module 35) and press #. (On LED touchpads, the Armed LED turns on, indicating the control panel is waiting for a programming location entry.)

4. Enter 09 and press #. (On LED touchpads, the Armed LED turns on and the Zone LEDs display the binary data for the current settings.)

5. To delete the sensor press 1. (On LED touchpads, the 1 LED turns off to indicate the feature change and the Ready LED flashes to indicate the change

request.)

6. Enter the * key then #. (On LED touchpads, the Ready LED stops flashing to indicate the new settings are stored in memory and the system automatically exits from that location.)

7. To Exit programming press (Exit key) (Exit key)

Wait 20 to 30 seconds or so then re-enter programming.

To Add sensor 9

1. Enter * 8 at the keypad. (On LED touchpads, the five function lights start flashing.)

2. Enter the program code (factory default is 9 7 1 3). (On LED touchpads, the service light flashes and the five function lights change from flashing to on steady.)

3. Enter the DIP switch setting module number of the wireless receiver(factory default on the NX548E is module 35) and press #. (On LED touchpads, the Armed LED turns on, indicating the control panel is waiting for a programming location entry.)

4. Enter 0 # to enter the sensor learning location. (On LED touchpads, the Ready LED turns on and the Armed LED turns off.)

5. Enter the zone number 09 and press *

6. Trip the desired transmitter (within 250 seconds) by opening the cover then closing it. Listen for the ding dong for confirmation.

7. Press (Exit key) (Exit key)