Note: When using an X10 siren with the Powermax+ system, you will be programming the system so the X10 siren is assigned as House Code A Device number 1.

In order for the X10 siren to work properly, turn the dials on the X10 siren to B 1 The correct programming steps are listed below

press NEXT until you see INSTALLERS MODE

press OK enter 9999 (or your installer code)

press NEXT until you see DEFINE OUTPUTS

press OK press NEXT until you see X-10 UNIT DEFINE

press OK you will see SET HOUSE CODE press OK

press NEXT until you see HOUSE CODE = A

press OK twice you should see DEVICE NUMBER

press NEXT for DEVICE 1

Continually press OK until you see LOCATION then press Next until you see

BY MEMORY press OK then press NEXT until you PULSE ACTIVE

press OK twice

then press AWAY and OK

That completes the programming